At 8,520 hours, NEW air compressor installed 

At 7,403 hours, NEW complete undercarriage installed

At 7,161 hours, NEW ARD head installed

At 7,161 hours, NEW machine chassis harness installed

At 5,695 hours, transmission was overhauled.

Upon arrival to our yard, all covers & guards were removed and unit was power washed

Local CAT dealer completed all the servicing and TA inspection:

NOTE: The CAT TA1 inspection included all engine and transmission pressures, stall speed, steering, brake & torque converter pressures

Updated all ECM's

Performed required calibrations

Cut open and inspected all other filters, no metals found

Replaced engine thermostats

Installed Reman water pump

Repaired wiring as required

Installed NEW engine belts

Installed NEW battery cables

Serviced batteries and connections

Installed NEW heater hoses

Performed ash burn

Sent out DPF for cleaning

Installed NEW DEF injector assembly

Ran DPR regen to ensure all was operating to spec

Completed bottom end bearing roll-in

Inspected engine oil pump

Resealed engine oil pan

Completed miscellaneous repairs from inspection

Marcel Equipment Limited then completed the following:

Performed operational and visual inspections

Completed repairs from CAT TA inspection

Removed final drive seal guards to clean & inspect

Installed track frame wear guides as required

Repaired pivot shaft lube assembly

Installed NEW rad cap 

Replaced lower rad hoses

Resealed starter

Repaired the seat assembly

REBUILT & resealed transmission pump

Resealed the priority valve

Installed all NEW powertrain hoses

Resealed right & left blade lift cylinders

Replaced bearings in blade lift cylinder mounting caps

Installed NEW left equalizer bar end bearing & pin

All controls, gauges and switches checked

All grease lines checked and unit greased

Blade will be checked over and any required repairs will be completed

All required cosmetic and welding repairs will be completed

Machine will then be sand blasted, primed, painted & detailed.