In 2015 at 9,145 hours, Marcel Equipment completed the following REBUILDING/RECONDITIONING of the machine as part of a sale;

REBUILT engine with all CAT OEM parts  

REBUILT torque with all CAT OEM parts

REBUILT transmission with all CAT OEM parts

REBUILT transfer case with all CAT OEM parts

REBUILT front axle with all CAT OEM parts

REBUILT rear axle with all CAT OEM parts

REBUILT rear axle trunnion mounts

REBUILT articulation hitch

REBUILT parking brake assembly

REBUILT hydraulic pump

REBUILT electrical / relay panel

RECONDITIONED cab

Radiator & all other coolers were sent out for cleaning & testing

Blade lift cylinder resealed

NEW blade cylinder mount bearings

Installed NEW bearing in cylinder mount yoke

Resealed both steering cylinders

Serviced & cleaned complete HVAC system

Replaced all required hoses, lines & tubes

Checked drive train & repaired as needed

Installed NEW fire suppression system

Machine was sand blasted & painted

Of those 9,145 hours at time of rebuild, 4,586 of them were idle hours

Upon arrival to our yard, all covers & guards were removed & machine was power washed

Both visual & operational inspections were completed

The machine was serviced as follows:

Engine oil filter was cut open & inspected - clean

Transmission oil & filter changed, filter cut open & checked - clean

Hydraulic oil & filter changed, filter cut open & checked - clean

Both differential oil levels good & oils clean

Articulation hitch was checked - good

Rear axle oscillation was checked - good

Engine, transmission & hydraulic oils were replaced

The following pressures were checked to ensure within OEM specs:

Transmission pump

Transmission lube

Torque inlet

Torque outlet

Steering

Pilot

Implement

Engine oil

Fuel

Accumulator

Boost

Stall speed

NEW radio installed

NEW wiper motor installed

Complete HVAC unit was serviced & cleaned 

Serviced A/C system

Installed NEW batteries

Serviced electrical bay

Replaced transfer case output seal

Resealed right & left side steering cylinders

Inspected parking brake assembly

Installed NEW seat cushion

NEW heater taps installed

Completed engine valve set

Replaced PCV filter

All grease points checked & machine greased

All repairs have been completed & machine will soon enter our weld shop for some cosmetic repairs.