The following are repairs completed by the CAT dealer prior to Marcel Equipment owning the machine:

At 4,105 hours, CAT dealer installed NEW updated high temp o-rings on transmission drive group and pump drive

At the same time, CAT dealer installed NEW updated rear crank seal

At 8,417 hours, CAT dealer REBUILT the transfer gear case

At 8,417 hours, CAT dealer installed NEW suspension bar bearings on both sides

At 9,109 hours,  CAT dealer installed NEW yoke for front driveshaft on transfer case

At 9,621 hours, CAT dealer line bored the box pin boxes and installed NEW bearings and pins

At 9,621 hours, CAT dealer installed NEW bearings on the front, center and rear axle A-frames

At 10,012 hours, CAT dealer performed full 2,000 hour service and engine valve set

At 10,373 hours, CAT dealer installed all NEW heater hoses from engine to heart core & new heater taps

At 10,654 hours, CAT dealer installed NEW pins & bearings on box hoist cylinders

At 10,654 hours, CAT dealer resealed both box hoist cylinders

At 10,654 hours, CAT dealer installed NEW center driveshaft and u-joints

At 10,654 hours, CAT dealer installed NEW yoke on center axle output

At 10,654 hours, CAT dealer installed NEW pins & bearings on center axle stabilized bar.