CAT Certified Powertrain (CPT) REBUILD completed at 13,322 hours

Upon arrival to Marcel Equipment, all covers were removed and machine was power washed

Operational and visual inspections were completed

Engine oil filter cut open and checked for contaminates - all clean

Transmission filter cut open and checked for contaminates - all clean

Hydraulic filters cut open and checked for contaminates - all clean

Hydraulic oil changed

Rear differential oil changed

Front differential oil clean

All magnetic plugs good

Following are repairs completed by Marcel Equipment at 23,068 hours:

Installed 4 NEW batteries and checked all wire connections

Installed NEW throttle shaft seal

Installed NEW bearings on blade lift cylinder

Checked accumulator pressure

Cleaned and checked park brake

Checked all grease lines and greased unit

Cleaned heater core

Installed rear pinion seal and repaired yoke

Replaced middle slip driveshaft yoke

Installed NEW hood actuator

Installed NEW engine crankshaft seal at vibration damper

Roll engine bearings - rod, main & thrust

Removed and checked engine oil pump

Installed NEW steering pins & bearings - both ends and both sides

Installed NEW A/C belt and alternator belt

Installed NEW radio

Cleaned and resealed HVAC unit

Installed NEW seat belt

NEW wiper motor was installed

Checked all gauges, controls & switches

A/C and heater checked

Articulation good

Oscillation good

The following pressures are all within OEM specs:

Transmission

Engine

Torque

Lube

Hydraulic

Steering

Pilot

Fuel 

Fan speed

All repairs have been completed

Unit will soon enter our paint facility where it will be sand blasted, primed, painted and detailed.