CAT 980K WHEEL LOADER (2012) - Unit #L9222
Machine Hours: 7840 - ECM Idle Hours: 2126


  • Caterpillar C13 ACERT Engine
  • Block Heater
  • Powershift Transmission
  • Joystick Steering
  • Cab (ROPS) with Air Conditioning
  • Ride Control
  • Load Sensing Hydraulics
  • Front and Rear Axle Oil Coolers
  • Michelin XMINE 29.5R25 Tires
  • NEW 29.5R25 L-3 Tires Available
  • High Ambient Cooling Arrangement
  • Rearview Camera
  • Cold Weather Arrangement
  • CAT 7.5 CU YD GP Bucket
  • Lights, Wipers, Heater, Mirrors
  • Rated at 406 HP
  • Approximately 69,000 LBS.

Repair / Condition Report

Upon purchase inspection, the following was completed (7840 HRS).

All guard and covers were removed for powerwashing.

Following are service and repairs completed by Marcel Equipment Limited:

Removed engine filter, cut it open and checked for contaminates, it was clean.

New engine oil was added.

Removed transmission filter, it was cut open and checked for contaminates and it was clean.

Removed hydraulic filters, they were cut open as well and both were clean.

Checked all four wheel planetaries, oil levels were good and oils were clean.

Checked the two differentials oil levels, they were good.

Magnetic plugs nice and clean.

Installed NEW pins and bushings on bucket to boom mounting.

Installed NEW pins on boom to loader frame.

Installed a NEW alternator / AC belt.

Checked engine high idle - 2250 RPM

Checked engine low idle - 800 RPM.

Checked cooling fan speed - OK.

Checked accumulator brake pressure - OK.

Checked all gauges, switches and controls for proper operation.

Checked heater and air conditioning.

Checked brakes, wipers, lights etc.

Load tested batteries - all good.

Checked all grease points and grease unit - all good.

All pressures were taken and are good (available).

This is an excellent loader, well maintained, ready to work.