CAT D8T WASTE HANDLER CRAWLER TRACTOR (2012) - Unit #D3628
Machine Hours: 9772 ECM Idle Hours: 2288





Price: Call for details
  • WARRANTY INCLUDED
  • Caterpillar C15 ACERT Engine
  • Engine Block Heater
  • Powershift Transmission
  • Auto Reverse Cooling Fan with Brush Guard
  • Cab (ROPS) with Air Conditioning
  • Cab air filtration system
  • Differential Steer
  • 22" Track Shoes
  • CAT Semi U Blade with Tilt and Trash Rack
  • Rear Striker Bar with Counterweight and Drawbar
  • Ripper Control Valve
  • Winch and Rippers are also Available
  • Factory Waste Handling Arrangement
  • Clamshell Final Drive Guards
  • Pivot Shaft Seal Guards
  • Turbine Pre-Cleaner
  • Debris Resistant Radiator
  • Fuel Tank Guard
  • Heavy Duty Bottom Guards
  • Fast Fuel Adapter
  • High Speed Oil Change
  • Fire Suppression System
  • Flood Lighting Package
  • Lights, Wipers, Heater, Mirror
  • AM/FM Radio, Beacon Lamp
  • CAT Dealer Serviced and Maintained Since New - Records are Available
  • Rated at 348 HP.
  • Approximately 86,000 LBS.


Repair / Condition Report

At 9227 hours, NEW DPF Filter, inlet module, and ARD head was installed.

NEW track groups were installed at 7450 hours. Only 20% wear currently.

At 5950 hours, due to loss of first gear, transmission and torque convertor were REBUILT.

Upon arrival to our yard, all covers and guards were removed and unit was powerwashed.

Local CAT dealer completed all the services and TA1 inspection:

NOTE: The CAT TA1 inspection included all engine and transmission pressures, stall speed, steering and brake and torque converter pressures.

- Changed engine oil and filter

- Cut open and inspected all  other filters, no metals found - all clean

- Changed trans breather, hydraulic tank breather, pivot shaft tank breather and fuel cap breather

- Changed ARD head spark plug

- Checked final drives and pivot shaft oil - all clean

- Load tested batteries

- Ran fuel system verification test

- Ran DPF regen

- Changed engine oil and filter

- Updated all ECM's

Following are repairs completed by Marcel Equipment at 9772 hours:

- Installed NEW air conditioning lines.

- Cleaned heater core and evaporator.

- Installed NEW accumulator.

- Installed NEW receiver dryer.

- Charged AC system and checked - all good.

- Installed NEW rad cap.

- Installed NEW pivot shaft seal - right side.

- Installed NEW serpentine belt.

- Resealed right blade lift cylinder.

- Oil pan mid section seeping oil, so we took the pan off to reseal.

- While pan was off, we took this opportunity to roll NEW CAT main and rod bearings and thrust bearings.

- Remove and checked engine oil pump.

- Installed NEW pins and bearings on left and right hard bar ends.

- Installed NEW bearings on pivot shaft left and right track frames.

- Installed NEW rubber pads for hard bar, left and right sides.

- Installed NEW bearings on lift cylinder mount.

- Installed REBUILT turbo charger.

- Installed REBUILT fuel injectors.

- Load tested batteries and repaired battery connections as needed.

- Removed and resealed starter mounting.

- Removed and rebuilt transmission pump.

- Checked all switches, gauges and controls - all good.

- All grease lines were checked and unit was greased.

- The tractor was just sandblasted, primed, painted and detailed.

- This unit is now ready to go.