CAT D6T XW CRAWLER TRACTOR (2012) - Unit #D3223
Machine Hours: 3800 ECM Idle Hours: 633


  • Caterpillar C9.3 ACERT Engine
  • Powershift Transmission
  • Cab (ROPS) with Air Conditioning
  • Differential Steer
  • CAT SALT Undercarriage with NEW 28" Shoes
  • Fuel Tank Guards
  • Heavy Duty Bottom Guards
  • Drawbar Counterweight
  • Ripper Control
  • Grade Control Ready
  • VPAT Blade
  • MS Ripper and Winch are Available
  • Front Pull Hook
  • Lights, Heater, Wipers
  • AM/FM Radio
  • Rated at 208 Net HP.
  • Approximately 55,000 LBS.

Repair / Condition Report

Upon arrival to our yard, all covers and guards were removed and unit was powerwashed.

Visual and operational inspection was completed.

Local CAT dealer completed the following inspections and repairs:

CAT T1 inspection completed.

Inspected magnetic plugs.

Checked any screens for debris.

Checked all oil levels.

Downloaded PSRPT

Changed engine oil and filter.

Changed all other filters on machine.

Cut open and inspected all filters, no metals or contaminates found.

Changed trans breather, hyd tank breather and fuel cap breather.

Changed ARD head spark plug.

Topped up all levels.

Checked final drive and pivot shaft oils - clean.

Tested batteries.

Ran fuel system verification test.

Ran DPF regen.

Flashed all ECM's that needed updating.

Finished TA1 inspection.

Performed TA2 pressure checks.

Found issues with pilot accumulator pressures.

Removed old accumulator.

Charged new one with nitrogen to spec.

Installed on machine.

Confirmed working properly and holding correct pressure.

Changed coolant lines from after treatment to engine.

Diagnosed issues with low implement pump pressures.

Found service mag for same issues with an updated part number.

Ordered new comprehensive valve.

Installed on machine and adjusted pressure to spec. 

Installed NEW track pads with hardware. 

Installed NEW track guide wear plates where needed. 

Installed NEW lift cylinder bearings and pins.

Installed NEW batteries.

Reman starter installed.

Checked switches, controls, gauges etc.

Checked air conditioning, heater, wipers.

Checked all grease points and grease machine.

Machine is in excellent condition and is ready to work.