CAT 980K WHEEL LOADER (2012) - Unit #L6621
Machine Hours: 8203 - ECM Idle Hours: 3059 - Load Factor: 19%

CAT 980K Wheel Loader - Forestry Spec




   $345,000.00
   $263,000.00

  • WARRANTY INCLUDED
  • Forestry Package - Includes: Additional Counterweight, Bottom Guarding and Heavy Duty Tilt Cylinders
  • 3rd Valve Auxiliary Hydraulics
  • Caterpillar C13 Tier 4 Interim Engine
  • Powershift Transmission
  • Cold Weather Arrangement
  • Cab (ROPS) with Air Conditioning
  • Joystick Steering
  • Ride Control
  • Flood Light Arrangement
  • Front and Rear Axle Oil Coolers
  • Turbine Precleaner
  • Rear View Camera
  • 29.5x25 Michelin XHA2 L3 Tires
  • Choice of 7.5 CU YD GP Bucket (Now On) or 10.75 CU YD Light Material Bucket - See Photos
  • Lights, Wipers, Heater, Mirrors
  • Rated at 406 HP.
  • Approximately 69,000 LBS.


Repair / Condition Report

Upon purchase inspection, the following was completed:

All oils were checked and were good.

Checked the transmission strainer and it was clean.

Completed a full visual and operational inspection.

Checked all cab functions.

Removed all covers from the machine and completely washed it.

Verified that all pressures and stall speeds are within Caterpillar specifications.

Checked to ensure fan speed was also within Caterpillar specifications.

Articulation is good.

Rear axle oscillation is also good.

Tested and serviced batteries and connections.

Installed a NEW seal on the front differential input.

Rechromed the lift cylinders.

Repaired lights as required.

Installed NEW boots on the control levers.

Calibrated the hydraulic system.

The following tests were performed by Marcel Equipment Limited:

Fuel Pressure = 100 PSI (Spec 85)

Engine Oil Pressure = 77 PSI (Spec above 35)

Boost Pressure = 29 PSI

Steering Pressure = 3680 PSI (Spec: 3700 +-100)

Implement = 4560 PSI (Spec: 4500 +-100)

Pilot = 483 PSI (Spec: 500 +-50)

Stall = 2070 rpm (Spec: 2044 +70-40)

Transmission:

Pump = 370 PSI (Spec: 346 +-17)

Converter Outlet = 80 PSI (Spec: 65 +15-7)

Converter Inlet = 120 PSI (Spec: 96 +-25)

Lube = 65 PSI (Spec: 51 +11-7)

This unit has gone through our shop and is ready to go.