CAT 814F WHEELED DOZER (1999) - Unit #D1595
Machine Hours: 16193


Engine and Transmission were Previously REBUILT by Caterpillar Dealer.

CAT 814F Wheeled Dozer




   $160,000.00
   $123,000.00

  • Caterpillar 3306T Engine
  • Engine Block Heater
  • Powershift Transmission
  • Cab (ROPS) with Air Conditioning
  • Enclosed Disc Brakes
  • 26.5 x 25 Tires
  • CAT U Blade with Twin Tilt
  • No Spin Front Differential
  • No Spin Rear Differential
  • Counterweight, Drawbar
  • Air Suspension Seat
  • Mirrors, Lights, Wipers
  • Heater, Inside Mirrors
  • AM/FM Radio
  • Rated at 254 HP.
  • Approximately 48,000 LBS.


Repair / Condition Report

Engine was previously REBUILT by the Caterpillar dealer - Dean Machinery.

Transmission was also previously REBUILT by the Caterpillar dealer - Dean Machinery.

Upon arrival to our yard, the following repairs were completed by Marcel Equipment Limited at 16193 hours:

All covers and guards were removed and unit was powerwashed.

Engine oil and filter were changed - 10W30 oil.

Engine oil filter was cut open and checked for contaminates, it was clean.

Transmission filter and oil were changed - T0430 oil.

Transmission filter was cut open and checked for contaminates, it was clean.

Changed the hydraulic oil.

Hydraulic filter was cut open and it was clean.

Front differential oil level was good and oil was nice and clean.

Rear differential oil level was good and oil was nice and clean.

Fuel filter was changed.

Inner and outer air filters were checked and they were clean.

Checked the parking brake and it was good.

Replaced the air conditioning belt.

Replaced the serpentine belt.

Replaced the left work light.

Replaced the right tail light.

Checked the fan hub and it was good.

Installed a NEW pin and bearing on the rod end of the left steering cylinder.

Installed a NEW pin and bearing on the right steering cylinder.

Resealed the right steering cylinder.

Installed NEW hydraulic cooler tubes.

Resealed both pilot valves.

Installed two NEW batteries.

REBUILT the left cylinder yoke using NEW bearings.

REBUILT the turbo charger.

Installed a NEW backup alarm.

Checked all grease points and greased unit.

Checked the articulation and it was good.

Checked the rear axle oscillation and it was good.

REBUILT the seat using NEW bearings, sliders, cushion and arm rest.

Checked all hoses.

Installed NEW heater hoses.

Checked the accumulator pressure and it was good - 1000 PSI.

Checked the engine block heater.

All pressures were taken and are within Caterpillar specifications.

This unit is in good condition and it ready to work.