CAT 730C ARTICULATED TRUCK (2015) - Unit #T1254
Machine Hours: 5488 - ECM Idle Hours: 2337


Click the View Video button to view the available video.

CAT 730C Articulated Truck




   $325,000.00
   $250,000.00

  • WARRANTY INCLUDED
  • Caterpillar C13 ACERT Engine
  • Engine Block Heater
  • Powershift/Autoshift Transmission
  • Secondary Steering
  • Cab (ROPS) with Air Conditioning
  • Hydraulic Disc Brakes
  • Engine Retarder
  • Michelin 750/65R25 Tires
  • 31 Ton Capacity/23 Cubic Yards
  • Tailgate is Available at Additional Cost
  • Rear Cab Screen
  • Rear View Camera
  • 12-24 Volt Receptacle
  • Lights, Heated Mirrors, Heater
  • Wipers, AM/FM Radio
  • Rated at 375 HP.
  • Approximately 53,130 LBS.


Repair / Condition Report

At 5236 hours, the local Caterpillar dealer installed a NEW DPF filter and reset the DPF service indicator.

At 5326 Hours, the Caterpillar dealer completed a full 2000 hour service on unit.

Upon arrival to our yard, all covers and guards were removed and unit was powerwashed.

Visual and operational inspections were completed by Marcel Equipment Limited.

Following are the service and repairs completed by Marcel Equipment Limited at 5425 hours:

Engine oil and filter were changed.

Engine oil filter was cut open and checked for contaminates, it was clean.

Transmission oil filter was cut open and checked for contaminates, it was clean.

Hydraulic oil filters were changed and filters were cut open and checked. They were clean.

Fuel filters were changed.

Fuel water separator was changed.

Checked the inner and outer air filters and they were clean.

Checked all grease points and greased unit.

Checked all the tire air pressures.

Checked all three differential oil levels and oils were clean.

Checked all six wheel planetary oil levels and oils were clean.

All magnetic plugs were clean.

Checked all lights, switches, gauges, etc. for proper operation.

Installed a NEW windshield washer tank.

Checked the articulation and it was good.

Checked the front suspension and it was within Caterpillar specifications.

Checked the steering system for play and it was good.

Checked for any oil leaks.

Tested the six wheel drive system and it was good.

All pressures were taken:

Transmission Pressure - Specs: 280-310 PSI - Actual: 285-315 PSI

Transmission Lube Pressure - Specs: 3-23 PSI - Actual: 9-40 PSI

Hoist Hydraulic Pressure - Specs: 3000 PSI - Actual: 2966 PSI

Steering Pressure - Specs: 3000 PSI - Actual: 2980 PSI

Engine Oil Pressure - Specs: 8-35 PSI - Actual: 34-69 PSI

Fuel Pressure - Specs: 85 PSI - Actual: 83-110 PSI

Turbo Boost - Specs: - Actual: 22 PSI

Fan Speed Minimum - Specs: 600+-100 RPM - Actual: 515 RPM

Fan Speed Maximum - Specs: 1400+- 100 RPM - Actual: 1400 RPM

This is an excellent and ready to work truck.