CAT 730 ARTICULATED TRUCK (2008) - Unit #T2187
Machine Hours: 9085 - ECM Idle Hours: 4569

CAT 730 Articulated Truck




Price: Call for details
  • WARRANTY INCLUDED
  • Caterpillar C11 ACERT Engine
  • Powershift/Autoshift Transmission
  • Cab (ROPS) with Air Conditioning
  • Hydraulic Disc Brakes
  • Retarder
  • 30 Ton Capacity
  • 23.5 x 25 Tires - 2 NEW Front Tires
  • Tailgate
  • Rear Window Screen
  • Mirrors, Lights, Wipers, Heater
  • Beacon Safety Light, AM/FM Radio
  • Ex-Municipal Unit
  • Rated at 325 GHP.
  • Approximately 50,000 LBS.


Repair / Condition Report

Installed 2 NEW 23.5 x 25 front tires.

Upon arrival to our yard, this unit was powerwashed, serviced and checked over.

Engine filter was cut open and checked for contaminates, it was clean.

Transmission filter was cut open and it was clean.

Hydraulic filter was also cut open and checked and it was clean as well.

All 3 differential oil levels were good and oils were clean.

All 6 wheel planetary oil levels were good and oils were clean.

Replaced the center differential vent hose.

REBUILT the center articulation using NEW pins and bearings.

Linebored and installed NEW pins and bearings on the dump box hinge.

Linebored and installed NEW pins and bearings on the box lift cylinders.

Installed a NEW transfer case suction hose.

Removed the transfer case and resealed and installed NEW clutch plates for the diff lock.

Installed NEW tail lights.

Repaired the beacon light.

Installed a NEW U joint at the transfer case outlet.

Checked the accumulator pressures.

Checked all grease points and greased unit.

Checked the 6 wheel drive and all is working well.

Installed a REBUILT starter.

Installed NEW batteries.

Transmission and hydraulic pressure tests were taken:

Torque Inlet Pressure - High Idle = 65 PSI - Specs: (70+-5 PSI)

Torque Inlet Pressure - Low Idle = 24 PSI - Specs:  (18+-5 PSI)

Torque Outlet Pressure - High Idle = 25 PSI - Specs: (30+-5)

Torque Outlet Pressure - Low Idle = 3 PSI - Specs: (5+-2)

Lube Pressure - High Idle = 18 PSI - Specs: (23+-5 PSI)

Lube Pressure - Low Idle = 3 PSI - Specs: (3+-2 PSI)

Transmission Pump - High Idle = 280 PSI - Specs: (260+-20 PSI)

Transmission Pump - Low Idle = 230 PSI - Specs: (240+-20 PSI)

Hoist Pressure = 3050 PSI - Specs: (3000+-100)

Steering Pressure = 3100 PSI - Specs: (3000+-100)

Hoist Pilot = 650 PSI - Specs: (500+-100)

High Idle = 2157 RPM - Specs: (2155+-40 RPM)

Removed and resealed the transmission as it was seeping between sections.

Removed and REBUILT the transfer case.

Installed a NEW left front shock bearing.

Installed a REBUILT starter.

Installed NEW batteries.

Replaced the left cylinder bushings.

Replaced the brake pads on the rear axle assembly.

Resealed the brake caliper on the right rear axle.

This is a good clean unit that is ready to work.